planetwatt.com
Help and Support => Archives => wattOS R9 => Topic started by: bushyiii on October 31, 2016, 07:29:09 PM
-
Installed the Brothers scanner driver, Simple Scanner application doesn't see the scanner. However, if I run lsusb I see this:"Bus 001 Device 002: ID 04f9:0272 Brother Industries, Ltd". Then run this command "sudo chmod a+w /dev/bus/usb/001/002" the problem is resolved. However with every reboot I have to go through the process again.
Is there any way to correct this permanently?
-
I seriously do not know anything about this. ;D But have you tried to download the drivers and reinstall them? Which tool did you use for installing the drivers?
Is there something useful in this link below?
https://ubuntuforums.org/showthread.php?t=2321613
-
Thanks for the link, I will work on it tomorrow.
-
Hi bushyiii
brother have a dedicated linux driver for their products also...
have a look here http://support.brother.com/g/s/id/linux/en/download_scn.html (http://support.brother.com/g/s/id/linux/en/download_scn.html)